Double tension tie HD2P
The two-part tension anchors have a large number of possible combinations. A total of 46 variants of combinations. As you can see we look at the individual needs of each problem and find a suitable optimal solution.
In the lower part are adapted for different sizes of loads and the required distances between the holes for the screws.
For example, at the tie rod HDBU379 suitable offset in relation to the prefabricated wall elements with a mounting plane, the distance of the screw hole to about 60 mm inward ..
S 250 GD + Z 275 according to DIN EN
275 g / m galvanized on both sides 20mm
• Setting up the base on site, does not interfere with traffic protruding metal parts and reduce the risk of injury.
Concrete, steel, wood, wood products.
• Two-part tension anchors have a large number of possible combinations. A total of 46 variants of combinations.
• As you can see, we look at the individual needs of each problem and find a suitable optimal solution.
Products with the HDU, HDB must be connected to the basics specified number of e-Jot screws JT2-3 / 5,5x25.
HD2P60G The product consists of a top part and a bottom part HDUF400G HDBU220G,
HD2PL40G The product consists of a top part and a bottom part HDUF250G HDBU379G.
* The weight of the upper / lower part
The lower part HDBU ... along with washers US40 / 50 / 10G used at the bottom HDBU220G and HBDU379G with U-disk US50 / 50 / 8G ..
These pads and e-jot screws must be ordered separately.
** Time to customer
n = nef according to ES5, Table 8.1;
Rlat.k = characteristic resistance CNA nail to cut
Rax.k = characteristic resistance CNA nail for recovery
* When using CNA4,0x50
** Full nailed 20 nails CNA
*** Partial nailed 14 nails CNA
Low values of the upper and lower parts
Anchor bolt evidence of the power factor screws F1.dx.
y = the upper and lower parts are packaged separately (and order)
S = the upper part are manufactured on request in the appropriate length
HD2P60G, HD2PL40G = are supplied in sets, or top and bottom